@article{oai:niigata-u.repo.nii.ac.jp:00003891, author = {岩部, 洋育 and 古泉, 昭彦 and 藤井, 義也 and 浅見, 敏彦}, issue = {540}, journal = {日本機械学会論文集. C編, 日本機械学会論文集. C編}, month = {Aug}, note = {This paper proposes a simple and accurate method for the prediction of the cutting force in end milling. The cutting force in end milling of a thick plate can be predicted by adding the cutting forces in end milling of a thin plate. The following were obtained from the comparison of the predicted cutting force with the experimental results. (1) The error of the predicted cutting force is reduced with a increased helix angle of the cutting edge of the end mill and a decreased radial depth of cut. (2) The error of the predicted cutting force of a 1-tooth end mill is less than about 200N under cutting conditions of 2~10mm radial and 2~20mm axial depth of cut and 10°~50° helix angle. The maximum error occurs at the helix angle of 10°, but the ratio of the error to the maximum cutting force is less than 10%. (4) The cutting force of a 4-tooth end mill can be predicted by superposition of that of a 1-tooth end mill. The maximum error and ratio are also less than 200N and 10% respectively.}, pages = {2746--2751}, title = {エンドミル加工における切削力の予測とその精度(重ね合わせ法による簡易予測法)}, volume = {57}, year = {1991} }