2024-03-29T12:12:25Z
https://niigata-u.repo.nii.ac.jp/oai
oai:niigata-u.repo.nii.ac.jp:00003816
2022-12-15T03:36:52Z
423:424:425
453:454
Transmission Error Analysis of Spiral Bevel Gears in Gleason System
グリーソン方式まがりばかさ歯車の回転伝達誤差解析
グリーソン方式まがりばかさ歯車の回転伝達誤差解析
川崎, 一正
45557
道脇, 宏和
45558
鈴木, 謙太郎
45559
田村, 久司
45560
Machine Element
Measurement
Gear
Spiral Bevel Gears
Gear Cutting
Gleason's Summary
Machine Setting
Tooth Bearing
Transmission Error
Coordinate Measuring Machine
The transmission errors of spiral bevel gears in Gleason system are analyzed in two cases. One is the analysis of hypothetical gears accurately cut according to Gleason's summary and the other is that of gears used actually. The tooth surfaces of the latter gears are measured by using a coordinate measuring machine, and the machine settings to generate the gears are estimated by the method of least squares so that the surface fits the measured data. The results of analysis showed that the tooth bearings obtained in both cases matched the desired ones, but the transmission errors differed from the desired, namely, they were not sufficiently small. In conclusion, although Gleason system pays attention to tooth bearing, it does not pay so with regard to the transmission errors.
journal article
日本機械学会
1999-11
application/pdf
日本機械学会論文集. C編
639
65
4476
4483
日本機械学会論文集. C編
AN00187463
03875024
https://niigata-u.repo.nii.ac.jp/record/3816/files/9_0144.pdf
jpn
http://ci.nii.ac.jp/naid/110002384529
日本機械学会
本文データは学会の許諾に基づくCiNiiからの複製である