2024-03-28T22:11:45Z
https://niigata-u.repo.nii.ac.jp/oai
oai:niigata-u.repo.nii.ac.jp:00003780
2022-12-15T03:36:50Z
453:454
468:469:470
Study on Tool Life and Surface Roughness of High Speed Milling of Hardened Steel by Small Size Ball End Mill
小径ボールエンドミルによる高硬度材の高速加工における工具寿命と仕上げ面粗さに関する研究
小径ボールエンドミルによる高硬度材の高速加工における工具寿命と仕上げ面粗さに関する研究
岩部, 洋育
45328
山口, 恒志
45329
清水, 啓輔
45330
中西, 賢介
45331
Ball End Mill
High Speed Milling
Hardened Steel
Tool Life
Surface Roughness
Flank Wear
Minimum Quality Lubrication
In this paper, the flank wear and the surface roughness of a machined surface are investigated by high speed milling of hardened steel on a small size ball end mill using a high speed spindle attachment. And also an investigation is carried out on the influence of a tool life on the minimum quality lubrication (MQL) method. The main results are as follows. (1) The flank wear of the cutting edge increases in proportion to the cutting length, and the flank wear shape gradually brings the shape of the actual cutting length close. (2) It is shown that the long tool life is obtained by the conditions of the step down pick feed and the down milling with MQL method to the end point of each milling process. (3) The surface roughness increases in proportion to the cutting length. But using the same cooling method described in (2), the small surface roughness of 3 μm is obtained till 2000m of cutting length. (4) Under the cutting conditions, bidirectional milling is an effective milling method by reason of the shortest cutting time that is about 70% of other types of milling and the longer tool life that is about 90% of the maximum tool life obtained by down milling.
journal article
日本機械学会
2003-11
application/pdf
日本機械学会論文集. C編
687
69
3116
3123
日本機械学会論文集. C編
AN00187463
03875024
https://niigata-u.repo.nii.ac.jp/record/3780/files/5_0005.pdf
jpn
日本機械学会